User Tools

Site Tools


Sidebar



I'm learning as I'm go. If you have some advice please send me an email: tjhowse at gmail.com

projects:crokinole_board:work_logs:work_log_10

What I want to accomplish

  • Make the posts,
  • Mark and drill the post positions.

What I've done

The easiest bit

I bought some stiff irrigation tubing of the correct outside diameter, and some stainless wood screws with heads slightly smaller than that. I put two layers of heat shrink on the top 1/2“ of the screw such that the tubing was a snug fit.

I calculated the distance between the eight post holes, and the distance between 16 post holes. I set up the laser line aligned with the straight lines on the board and stepped at 16-distance from where the laser intersected the centre circle. I then set the calipers to the eight-distance and stepped around the circle. When I got back to the first hole I was about 2mm out. Not too bad. I then drilled out the holes with a 2mm drill bit, in a state of pure terror.

What I want to accomplish next time

  • Varnish the base,
  • Join the top to the base,
  • Finish the bottom of the base.
projects/crokinole_board/work_logs/work_log_10.txt · Last modified: 2019/07/27 02:56 by tjhowse