projects:crokinole_board:work_logs:work_log_5
This is an old revision of the document!
Table of Contents
What I want to accomplish
- Cut out the top board.
What I've done
Dithered a lot
Dither dither.
Just do it
I felt like I'd done enough experiments and preparation. I threw down some sacrificial particleboard, marked the centre of the board and drilled a 12mm hole, then set up my jig and went for it.
Huzzah!
Barely cut into the particle board underneath.
It looks great!
A sand around the circumference with some 180 grit sandpaper removed the burrs. I am very extremely happy with the result. There are two or three small voids around the edge. I picked up some wood putty of approximately the right colour and smooshed it into them. I am confident it will sand up very nicely.
What I want to accomplish next time
- Glue the offcuts and cut out the base,
- Drill the hole in the centre of the top,
- Attach the bands to the base.
projects/crokinole_board/work_logs/work_log_5.1562762646.txt.gz · Last modified: 2019/07/10 12:44 by tjhowse