Differences

This shows you the differences between two versions of the page.

--- projects:sand_drawing:work_logs:even_mode_software [2020/05/26 11:57] – tjhowse
+++ projects:sand_drawing:work_logs:even_mode_software [2020/06/04 00:36] (current) – tjhowse
@@ Line 11: / Line 11: @@
 However the generated GCODE was quite large, about 40kB, and the ESP32 threw an error when trying to receive it. It couldn't allocate enough ram. There's a few ways of solving this. I could potentially chunk up large programs into smaller pieces and send them through in a few separate messages, then stitch them together before playback.
-Another, much cooler solution, would be to listen to another MQTT topic that can be used to transmit Python generator code to the robot. This would be a cool way of sending quite complex pattern generators to the robot without using much RAM.
+Another, much cooler, solution would be to listen to another MQTT topic that can be used to transmit Python generator code to the robot. This would be a cool way of sending quite complex pattern generators to the robot without using much RAM.
 === Generators ===