projects:sand_drawing:work_logs:even_mode_software
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
projects:sand_drawing:work_logs:even_mode_software [2020/05/15 06:24] – created tjhowse | projects:sand_drawing:work_logs:even_mode_software [2020/06/04 00:36] (current) – tjhowse | ||
---|---|---|---|
Line 11: | Line 11: | ||
However the generated GCODE was quite large, about 40kB, and the ESP32 threw an error when trying to receive it. It couldn' | However the generated GCODE was quite large, about 40kB, and the ESP32 threw an error when trying to receive it. It couldn' | ||
- | Another, much cooler | + | Another, much cooler, |
+ | |||
+ | === Generators === | ||
+ | |||
+ | I wrote the structure to support sending short snippets of python code to the robot. These snippets must implement a generator function, named " | ||
+ | |||
+ | I also added code to save/ | ||
====== What I want to accomplish next time ====== | ====== What I want to accomplish next time ====== | ||
* Build the electronics. | * Build the electronics. |
projects/sand_drawing/work_logs/even_mode_software.1589523880.txt.gz · Last modified: 2020/05/15 06:24 by tjhowse