Differences

This shows you the differences between two versions of the page.

--- projects:crokinole_board:work_logs:work_log_8 [2019/07/14 02:47] – created tjhowse
+++ projects:crokinole_board:work_logs:work_log_8 [2019/07/14 02:48] – tjhowse
@@ Line 27: / Line 27: @@
 Second half.
-It was much easier to apply this second layer with something to clamp to. I ended up with some gaps between the two layers after the glue dried. I worked some PVA into the gap with a brush and pinched the edge with a clamp. This worked well. The two joins in the outer ring look very nice, almost perfectly flush. I'm happy with how they look. If I were to do this again I would probably reduce the diameter of the circle a little such that the outer band was a bit under 2.4m, so I could use a whole strip and only have one join.
+It was much easier to apply this second layer with something to clamp to. I ended up with some gaps between the two layers after the glue dried. I worked some PVA into the gap with a brush and pinched the edge with a clamp. This worked well. The two joins in the outer ring look very nice, almost perfectly flush. I'm happy with how they look. If I were to do this again I would probably reduce the diameter of the circle a little such that the outer band was a bit under 2.4m, so I could use a whole strip and only have one join per edge layer.
 It was a bit tricky to get the circular bend of the strip to continue all the way to the end. I came up with a good solution to this, but unfortunately I didn't get a photo. You'll have to endure mspaint.