projects:crokinole_board:work_logs:work_log_7
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
projects:crokinole_board:work_logs:work_log_7 [2019/07/10 13:02] – tjhowse | projects:crokinole_board:work_logs:work_log_7 [2022/01/23 00:23] (current) – tjhowse | ||
---|---|---|---|
Line 1: | Line 1: | ||
{{indexmenu_n> | {{indexmenu_n> | ||
+ | [<6>] | ||
====== What I want to accomplish ====== | ====== What I want to accomplish ====== | ||
* Drill the hole in the centre of the top board. | * Drill the hole in the centre of the top board. | ||
Line 17: | Line 18: | ||
Rubbish. | Rubbish. | ||
- | I found that the point would wander in the soft wood and the bit would drive across the surface a small distance before biting, leaving a shallow groove which would ruin the board. The drill press worked because it rigidly held the bit in place so it could only travel downwards. My solution was to use the drill press to cut a hole through some hardwood and screw it to a long bit of wood to act as a jig for cutting the centre hole. | + | I found that the point would wander in the soft wood and the bit would drive across the surface a small distance before biting, leaving a shallow groove which would ruin the board. The drill press worked because it rigidly held the bit in place so it could only travel downwards. |
+ | |||
+ | My solution was to use the drill press to cut a hole through some hardwood and screw it to a long bit of wood to act as a jig for cutting the centre hole. | ||
{{: | {{: | ||
Line 33: | Line 36: | ||
* Attach the bands to the base. | * Attach the bands to the base. | ||
+ | [<6>] |
projects/crokinole_board/work_logs/work_log_7.1562763750.txt.gz · Last modified: 2019/07/10 13:02 by tjhowse