projects:crokinole_board:work_logs:work_log_7
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
projects:crokinole_board:work_logs:work_log_7 [2019/07/10 13:02] – created tjhowse | projects:crokinole_board:work_logs:work_log_7 [2022/01/23 00:23] (current) – tjhowse | ||
---|---|---|---|
Line 1: | Line 1: | ||
{{indexmenu_n> | {{indexmenu_n> | ||
+ | [<6>] | ||
====== What I want to accomplish ====== | ====== What I want to accomplish ====== | ||
* Drill the hole in the centre of the top board. | * Drill the hole in the centre of the top board. | ||
Line 7: | Line 8: | ||
=== This damn hole === | === This damn hole === | ||
- | I need to cut a 1-3/8" (35mm) hole in the centre of the top board. This is very scary. I bought a set of very rubbish forstner bits and was very disappointed in their performance. | + | I need to cut a 1-3/8" (35mm) hole in the centre of the top board. This is scary. I bought a set of rubbish forstner bits and was very disappointed in their performance. |
{{: | {{: | ||
Line 17: | Line 18: | ||
Rubbish. | Rubbish. | ||
- | I found that the point would wander in the soft wood and the bit would drive across the surface a small distance before biting, leaving a shallow groove which would ruin the board. The drill press worked because it rigidly held the bit in place so it could only travel downwards. My solution was to use the drill press to cut a hole through some hardwood and screw it to a long bit of wood to act as a jig for cutting the centre hole. | + | I found that the point would wander in the soft wood and the bit would drive across the surface a small distance before biting, leaving a shallow groove which would ruin the board. The drill press worked because it rigidly held the bit in place so it could only travel downwards. |
+ | |||
+ | My solution was to use the drill press to cut a hole through some hardwood and screw it to a long bit of wood to act as a jig for cutting the centre hole. | ||
{{: | {{: | ||
Line 33: | Line 36: | ||
* Attach the bands to the base. | * Attach the bands to the base. | ||
+ | [<6>] |
projects/crokinole_board/work_logs/work_log_7.1562763728.txt.gz · Last modified: 2019/07/10 13:02 by tjhowse