projects:crokinole_board:work_logs:work_log_4
This is an old revision of the document!
Table of Contents
What I want to accomplish
- Cut the lines in the main board.
What I've done
Aaarrgh! Scary!
Use a bolt or some threaded rod to securely clamp the axle in the centre rather than resting the shaft in the hole. if the axle moves by a millimetre the lines will be bad.
What I want to accomplish next time
- Varnish a piece of scrap ply and sand it, then varnish it, then sand it…
- Work out how to mark the lines on the board.
projects/crokinole_board/work_logs/work_log_4.1562636178.txt.gz · Last modified: 2019/07/09 01:36 by tjhowse