projects:crokinole_board:work_logs:work_log_10
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
Last revision | |||
— | projects:crokinole_board:work_logs:work_log_10 [2019/07/27 02:56] – created tjhowse | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | {{indexmenu_n> | ||
+ | ====== What I want to accomplish ====== | ||
+ | * Make the posts, | ||
+ | * Mark and drill the post positions. | ||
+ | ====== What I've done ====== | ||
+ | |||
+ | === The easiest bit === | ||
+ | |||
+ | I bought some stiff irrigation tubing of the correct outside diameter, and some stainless wood screws with heads slightly smaller than that. I put two layers of heat shrink on the top 1/2" of the screw such that the tubing was a snug fit. | ||
+ | |||
+ | {{: | ||
+ | |||
+ | I calculated the distance between the eight post holes, and the distance between 16 post holes. I set up the laser line aligned with the straight lines on the board and stepped at 16-distance from where the laser intersected the centre circle. I then set the calipers to the eight-distance and stepped around the circle. When I got back to the first hole I was about 2mm out. Not too bad. I then drilled out the holes with a 2mm drill bit, in a state of pure terror. | ||
+ | |||
+ | ====== What I want to accomplish next time ====== | ||
+ | |||
+ | * Varnish the base, | ||
+ | * Join the top to the base, | ||
+ | * Finish the bottom of the base. |
projects/crokinole_board/work_logs/work_log_10.txt · Last modified: 2022/01/23 00:23 by tjhowse