{{indexmenu_n>2}}
[<6>]
====== What I want to accomplish ======
  * Do some test cuts of some scrap plywood with the router,
  * Build a circle-cutting jig,
  * See how plywood sands,
  * Test out the stain,
  * Test out the varnish.

====== What I've done ======

=== Circle-cutting jig ===
{{:projects:crokinole_board:work_logs:pasted:20190705-124801.png}}

I inherited this router from my father in law. It took a moderate amount of WD40 and violence but I got all the moving parts moving. It's quite powerful, and takes 1/2" bits. Some of the attachments are missing but I bodged together the above quickly. There is very little flex or wobble in this system, so it should cut good circles.

=== Test cuts ===
I got some old scrap bits of plywood and rounded off one of the ends. I tried a few shallow cuts with a 8mm straight router bit and it was effortlessly cutting through without slowing down or leaving much of a burr. I haven't concluded whether it's better to move in one direction or the other. I imagine as long as the RPM remains high there isn't much of a difference.

{{:projects:crokinole_board:work_logs:pasted:20190705-125521.png}}

I did have some blow-out at the start and ends of the cut where one of the internal layers was spat out the side. I won't have this when cutting a circle, because there are no ends. The cut also exposed some internal voids in the ply: knots laminated on both sides. I'm not sure what I'll do if I encounter those when cutting the proper board. If there's only a few I can fill them with sawdust and PVA. If there's lots I might have to go up to marine grade ply to get the finish I want.

{{:projects:crokinole_board:work_logs:pasted:20190705-125530.png}}

I ran a great many cuts in different directions with different feedrates.

{{:projects:crokinole_board:work_logs:pasted:20190707-031415.png}}

My conclusion is that the direction doesn't matter all that much. Variability in the texture of the ply makes a bigger difference. This said, I generally got the best results moving at about 10-20mm/sec with a 6mm straight bit cutting all the way through 12mm ply, turning counter-clockwise with a clockwise-spinning bit.

=== Stain test ===
{{:projects:crokinole_board:work_logs:pasted:20190705-125556.png}}

I also sanded and stained a scrap piece of ply. I started with 80-grit and ended up with 320 grit, sanding by hand with a sanding block. The surface was smooth but lumpy on a larger scale. I think I need to spend longer with the coarser sandpaper to even out the bumps. I'll be sanding the actual board with an orbital sander, so it won't be so tiring.

{{:projects:crokinole_board:work_logs:pasted:20190705-125756.png}}

I dusted the wood off and put a moderately thick coat of stain on and wiped most of it off with a chux after a minute or two. There are some deep scratches from the coarser grades of sandpaper. I think I just need to spend longer sanding with the finer grades to remove these.

====== What I want to accomplish next time ======

  * Go through a few varnish -> sand -> varnish cycles and see how this scrap piece improves,
  * Build a wood steamer and bend the edge strips.
[<6>]