projects:blinker:work_logs:3_electronics
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| projects:blinker:work_logs:3_electronics [2022/02/27 05:26] – tjhowse | projects:blinker:work_logs:3_electronics [2022/02/27 05:40] (current) – tjhowse | ||
|---|---|---|---|
| Line 61: | Line 61: | ||
| * The firmware in the USPasp was too old to support TPI, | * The firmware in the USPasp was too old to support TPI, | ||
| * The JP3 jumper was not installed, this is required to enable 1 MHz programming speeds, | * The JP3 jumper was not installed, this is required to enable 1 MHz programming speeds, | ||
| - | * I had to use Zadig to install the libusbK v3.1.0.0 driver. | + | * I had to use Zadig to install the libusbK v3.1.0.0 driver, |
| + | * Arduino IDE reporting avrdude failure when it was actually succeeding. | ||
| After solving all of those problems I eventually got some basic code onto it and and recorded a progress video. | After solving all of those problems I eventually got some basic code onto it and and recorded a progress video. | ||
projects/blinker/work_logs/3_electronics.1645939599.txt.gz · Last modified: 2022/02/27 05:26 by tjhowse