User Tools

Site Tools


projects:glass_sphere:work_logs:work_log_6

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision
Previous revision
Next revisionBoth sides next revision
projects:glass_sphere:work_logs:work_log_6 [2019/02/20 12:36] – created tjhowseprojects:glass_sphere:work_logs:work_log_6 [2019/02/24 05:36] tjhowse
Line 14: Line 14:
 {{:projects:glass_sphere:work_logs:pasted:20190220-123604.png}} {{:projects:glass_sphere:work_logs:pasted:20190220-123604.png}}
  
 +Initial results were promising.
 +
 +{{:projects:glass_sphere:work_logs:pasted:20190224-052205.png}}
 +
 +{{:projects:glass_sphere:work_logs:pasted:20190224-052232.png}}
 +
 +However during the rough grinding pass one of the slugs fell in half.
 +
 +{{:projects:glass_sphere:work_logs:pasted:20190224-052420.png}}
 +
 +A gentle tap with a hammer split another in half too.
 +
 +{{:projects:glass_sphere:work_logs:pasted:20190224-052502.png}}
 +
 +{{:projects:glass_sphere:work_logs:pasted:20190224-052532.png}}
 +
 +{{:projects:glass_sphere:work_logs:pasted:20190224-052547.png}}
 +
 +I believe there are two problems:
 +
 +  * There are veins of impurities running through the glass,
 +    * These will create a weak point for a crack to start.
 +  * My tempering profile could be improved,
 +    * The current profile I'm using was created for tempering float glass. Container glass is slightly different, and so may require a different profile.
  
 === Video === === Video ===
Line 23: Line 47:
 ====== What I want to accomplish next time ====== ====== What I want to accomplish next time ======
  
-  * Polish the slugs.+  * Read this: http://www.glassblower.info/books/TheGlassTemperingHandbook.pdf, 
 +  * Adjust my temperature profile accordingly, 
 +  * Wash my glass in HCl to clean off impurities, 
 +  * Make better slugs.
  
  
projects/glass_sphere/work_logs/work_log_6.txt · Last modified: 2022/01/23 00:24 by tjhowse