projects:blinker:work_logs:9_resin_casting
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| projects:blinker:work_logs:9_resin_casting [2022/04/18 00:28] – tjhowse | projects:blinker:work_logs:9_resin_casting [2022/04/18 05:02] (current) – tjhowse | ||
|---|---|---|---|
| Line 46: | Line 46: | ||
| This seemed to indicate that the voltage limit was related to the temperature of the panel. Part of the way through this test the panel fell into shade, probably at the inflection point at 2710 seconds. | This seemed to indicate that the voltage limit was related to the temperature of the panel. Part of the way through this test the panel fell into shade, probably at the inflection point at 2710 seconds. | ||
| + | |||
| + | I built a new blinker with two 35F supercaps attached and ran another test. | ||
| + | |||
| + | {{: | ||
| + | |||
| + | Looking good! | ||
| ==== Failure ==== | ==== Failure ==== | ||
projects/blinker/work_logs/9_resin_casting.txt · Last modified: 2022/04/18 05:02 by tjhowse